现在位置:首页 > 微波射频和天线设计 > ADS > 设计讨论 > 无源的电感仿真出增益来了

无源的电感仿真出增益来了

录入:mweda    点击:
用的AVX的电感,仿真结果大家看看吧,居然还有放大。
是在搞不懂了
仿真信息输出:
Simulation / Synthesis Messages
Warning detected by hpeesofsim during SP analysis `SP1'.
While evaluating `SNP2.X1.CMP1.All':
Extrapolation on independent variable `freq' was detected.
Warning detected by hpeesofsim during SP analysis `SP1'.
While evaluating `SNP2.X1.CMP1.Z[1]':
Extrapolation on independent variable `freq' was detected.
Warning detected by hpeesofsim during SP analysis `SP1'.
While evaluating `SNP3.X1.CMP1.All':
Extrapolation on independent variable `freq' was detected.
Warning detected by hpeesofsim during SP analysis `SP1'.
While evaluating `SNP3.X1.CMP1.Z[1]':
Extrapolation on independent variable `freq' was detected.
Status / Summary

\\

已经超出S参数模型的频率范围了,在超出时软件会采用外插的方法绘出超出部分的曲线, 外插往往会不准。这就造成了你看到的现象。仿真信息中的警告也说明了这一点。

就是说模型里面只有特定频率范围的S参数了?
原来是这样,多谢多谢啦!

声明:网友回复良莠不齐,仅供参考。如需更专业系统地学习ADS,可以购买资深专家讲授的ADS最新视频培训课程

上一篇:哪里有ads layout的详细资料?
下一篇:功分器的问题

ADS培训教程和培训视频more...
ADS视频学习培训教程