现在位置:首页 > 微波射频和天线设计 > ADS > 设计讨论 > 联合仿真lna 出现如下问题

联合仿真lna 出现如下问题

录入:mweda    点击:
Simulation / Synthesis Messages
Warning detected by hpeesofsim during TRAN analysis `SP1'.
COMPONENT `X4_LNA_schematic_13_1':
Simulator uses frequency lower than frequency range of Momentum model. The S-parameters are extrapolated.
Warning detected by hpeesofsim during TRAN analysis `SP1'.
COMPONENT `X4_LNA_schematic_13_1':
The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values.
Warning detected by hpeesofsim during TRAN analysis `SP1'.
COMPONENT `X4_LNA_schematic_13_1':
The model for the Layout Component is reused from the ModelDatabase.
Warning detected by hpeesofsim during SP analysis `SP1'.
The simulation temperature (25.0 C) is not the same as the IEEE standard
noise temperature (290 K or 16.85 C) in the noise analysis `SP1'.
If the simulation temperature is not equal to the IEEE standard temperature,
then the loss and the noise figure will not agree for a passive circuit.
The `Temp' parameter on the Options item can be set to 16.85 C to
eliminate this warning message.
仿真几个小时之后给出这个提示,仿真结果S21为负值,噪声到70多最小噪声也是70多,请教是什么地方错误造成的,非常感谢。

你确定线都连好了?

我最近仿真也总是出现 这个The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values不知道什么原因啊,坐等高手解答

我也出现问样问题了,望解答

声明:网友回复良莠不齐,仅供参考。如需更专业系统地学习ADS,可以购买资深专家讲授的ADS最新视频培训课程

上一篇:momentum优化步骤
下一篇:ADS co-simulation "syntax error"

ADS培训教程和培训视频more...
ADS视频学习培训教程