虚心向工程师学习,谢谢!
1. The port mode Eigensolver(本征求解器) failed because the maximum number
of iterations has been reached.
2. Single-ended definition requires a separate mode set for each pin
.Please check waveguide Port Number.
3. The propagation constant of mode1 is zero ,cannot continue.
4. Waveguide for port nuber 1 is too short. The waveguide must be
homogeneous for at least three mesh planes along propagation direction.
5. Too few conductors detected .Conductors might be short-circuited in
port plane.
6. On port 2 multiple potential definitions of the same set are located on one conductor ,or a symmetry condition is incompatible with thepotential definitions.
声明：网友回复良莠不齐，仅供参考。如需更专业系统地学习CST，可以购买资深专家讲授的CST最新视频培训课程。
